Engine Dynamometers - X Series
(Engine Dyno)
Power Test water brake engine dynamometers are designed for testing a wide range of equipment with one dynamometer. Each of these fixed base dynamometers may be used for continuous-duty power verification, quality assurance, engine development, endurance, and certification tests.
Power Test absorbers use water directly within the absorption chamber for applying load to an engine. The water requirements depend upon the load requirements, thereby conserving water and allowing low minimum load conditions. Unlike other dynamometers, an interruption in water flow will not cause expensive failures and prolonged down time. In addition, our X Series dynamometers feature removable bearing and seal housings, allowing in-cell renewal.
X Series Water Brake Engine Dynamometers
| 50X |
up to
1000 HP
|
50X Engine Dynamometers
For testing electric motors, industrial gasoline and light to medium range diesel applications. The 50X series dynamometers feature non-ferrous alloy construction for reduced inertia. Power ranges from 20-1000 HP, speeds to 6,000 RPM. |
| 35X |
up to
2100 HP
|
35X Engine Dynamometers
For testing the majority of diesel engines, the 35X is available in six configurations for testing from 50 HP to 2,100 HP at speeds up to 4,000 RPM. |
| 45X |
up to
4500 HP
|
45X Engine Dynamometers
For testing on-highway through off-highway and marine diesel applications, the 45X is available in five configurations for testing from 100 HP to 4,500 HP at speeds to 4,000 RPM. The 45X may also be used in tandem applications for increased testing capabilities.. |
|
